Concrete Slab
Performed by removing existing material as required. Fine
grading and compacting sub base with vibratory equipment. Then
placing concrete in a depth of 4”-10” slab. Concrete strength
shall range from 3,000-5,000 psi depending upon requirements
set forth. All concrete shall be reinforced with wire mesh
as required.
Concrete Curb
We shall excavate a new trench. Compact existing sub base
and establish grade. Wood forms to be set along string line
set in the field. Concrete shall be placed between forms with
expansion joint set every 20 feet. Forms to be removed and
wood floated to meet desired finish.
Concrete Pavers
Existing material is excavated 6”-8” in depth depending upon
soil conditions. Install graded base aggregate to desired depth
then compact. Compact aggregate with a vibratory plate compactor
in lifts to achieve proper compaction rate. Install 1” of fine
Long Island sand. Set new pavers in a pattern to be agreed
upon prior to installation. Sweep in additional sand between
all stones as needed. Compact in place using a vibratory plate
compactor to set stone. Repeat until all joints are filled
with sand.
Curbing (Granite/ Belgium Block)
We shall excavate a new trench and prepare subgrade to meet
proper elevation. Block shall be placed in 4”-6” of concrete.
Mortar for joints between adjacent block shall be a mixture
of cement and sand.
Paving Stones
The area will be prepared accordingly prior to installation.
Excavation will allow for placement of a foundation. Stone
bedding is leveled and prepared before installing the paving
stones. The stones are then placed at a 90-degree angle according
to the chosen design. Aprons (Granite/ Belgium Block)
We shall excavate and remove existing material to a depth
of 10”-12” depending upon sub base material. A new concrete
slab with wire mesh steel reinforcement is to be installed.
Install, set and point block by using a mixture of Portland
cement and sand.
Back to Services
|
